Arctic Spa Cover Saver Straps

Step 1: Center the cover on the hot tub so it is even on all four sides. The center support bar has to be 1.5 inches from the center of the cover. 

Note: When using Cover Saver with new or existing lifters, make sure the center bar is 1.5 inches away from the center. ON existing lifters, you may have to adjust the side pivot arms by removing the screws to allow the cover support arms to move.

Step 2: One of the two pieces of Velcro should be placed 1/2 inch from the inside edge of the cover handles or divided evenly across the length of the cover. 

Note: There are two supports to be installed. To permanently apply Velcro, use silicon or Crazy Glue (not supplied)

Step 3: Thread the strap through the buckle as shown. Repeat for the other strap.